DS18B20Z/T&R【PDF 7/22 页】IC THERM MICROLAN PROG-RES 8SOIC

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录40

3页 4页 5页 6页 [7页]8页 9页 10页 11页

DS18B20

7 of 22

MEMORY

The DS18B20s memory is organized as shown in Figure 7. The memory consists of an SRAM

scratchpad with nonvolatile EEPROM storage for the high and low alarm trigger registers (T

and T

)

and configuration register. Note that if the DS18B20 alarm function is not used, the T

and T

registers

can serve as general-purpose memory. All memory commands are described in detail in the DS18B20

Function Commands section.

Byte 0 and byte 1 of the scratchpad contain the LSB and the MSB of the temperature register,

respectively. These bytes are read-only. Bytes 2 and 3 provide access to T

and T

registers. Byte 4

contains the configuration register data, which is explained in detail in the Configuration Register section.

Bytes 5, 6, and 7 are reserved for internal use by the device and cannot be overwritten.

Byte 8 of the scratchpad is read-only and contains the CRC code for bytes 0 through 7 of the scratchpad.

The DS18B20 generates this CRC using the method described in the CRC Generation section.

Data is written to bytes 2, 3, and 4 of the scratchpad using the Write Scratchpad [4Eh] command; the data

must be transmitted to the DS18B20 starting with the least significant bit of byte 2. To verify data

integrity, the scratchpad can be read (using the Read Scratchpad [BEh] command) after the data is

written. When reading the scratchpad, data is transferred over the 1-Wire bus starting with the least

significant bit of byte 0. To transfer the T

, T

and configuration data from the scratchpad to EEPROM,

the master must issue the Copy Scratchpad [48h] command.

Data in the EEPROM registers is retained when the device is powered down; at power-up the EEPROM

data is reloaded into the corresponding scratchpad locations. Data can also be reloaded from EEPROM to

the scratchpad at any time using the Recall E

[B8h] command. The master can issue read time slots

following the Recall E

command and the DS18B20 will indicate the status of the recall by transmitting 0

while the recall is in progress and 1 when the recall is done.

Figure 7. DS18B20 Memory Map

SCRATCHPAD

(POWER-UP STATE)

Byte 0 Temperature LSB (50h)

Byte 1 Temperature MSB (05h)

EEPROM

Byte 2 T

Byte 3 T

Byte 4 Configuration Register*

Configuration Register

Byte 5 Reserved (FFh)

Byte 6 Reserved

Byte 7 Reserved (10h)

Byte 8 CRC*

*Power-up state depends on value(s) stored in EEPROM.

85癈

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式